How do i replace the drum on my Workcentre 7855?

A message will be displayed on the Control Panel when a Drum Cartridge needs to be replaced.

CAUTION: Do not expose the Drum Cartridges to direct sunlight or strong indoor fluorescent lighting. Do not touch or scratch the surface of the drum.

  1. Remove the new Drum Cartridge from its packaging and place it on a flat surface near the machine. Do not place the Drum Cartridge upright or remove the black protective sheet from the cartridge.
  2. Make sure the machine has stopped copying / printing.
  3. Open the Front Door of the printer.

    Open the machine's Front Door
     
  4. Turn the release lever on the left side of the Drum Cartridge Cover to the left to unlock the cover.

    Turn the release lever on the left side of the Drum Cartridge Cover
     
  5. Pull the cover open to access the four Drum Cartridges.

    Pull the cover open to access the four Drum Cartridges
     
  6. Grasp the orange handle of the appropriate Drum Cartridge and gently pull it out of the printer. 

    Gently pull out the Drum Cartridge
     
  7. Place the used cartridge in the bag supplied in the package and put it in the box that the new cartridge came in.

    NOTE: To return the used Drum Cartridge for recycling, follow the instructions included with the new cartridge. If the instructions or shipping label are not available, click on the [Recycling] link in the Product Resources section for additional information.
     
  8. Remove the packaging material from the end of the new Drum Cartridge.
  9. Rest the new cartridge, along with its black plastic protective shield, in the cartridge slot. Make sure to load the cartridge in the direction of the arrow on the top of the shield.
  10. Keep the cartridge in the slot and remove the black paper by pulling it to the left.

    Remove the black paper by pulling it to the left
     
  11. Pull off the tape from the top of the cartridge shield.

    Pull off the tape from the top of the cartridge shield
     
  12. Hold the shield and push the cartridge into the machine using the light orange handle. Continue pushing until it stops.
  13. Remove the protective shield.
  14. Push the cartridge into the machine until it comes to a stop.

    Push the cartridge into the machine until it comes to a stop
     
  15. Lift up the Drum Cartridge Cover.

    Lift up the Drum Cartridge Cover
     
  16. Turn the release lever on the left side of the Drum Cartridge Cover to the right to lock the Drum Cartridges into position.

    Lock the Drum Cartridges into position
     
  17. Close the Front Door. If the Front Door is not completely closed a message will be displayed and the machine will not operate.
  18. Dispose of the protective shield and tape as normal office waste.

Leave a Reply

Your email address will not be published. Required fields are marked *